|
Hydraulic Compression Moulding Press Manual compression moulding press 1. Pressing Force 10MT 2. Pressing Direction Down Acting 3. Cylinder Bore dia. 110mm 4. Piston Rod dia. 90mm 5. Press Stroke 275mm 6. Maximum Day-light 300mm 7. Minimum Day-light 25mm 8. Distance between Tie Bars 350x350mm 9. Tie Bar size 50mm 10. Mould Plate Size 300x300mm 11. Platen Size 500x300 mm 12. Mould Closing/Pressing Speed 19 mm/sec. 13. Mould Opening Speed 60 mm/sec. 14. Platen Heating capacity(Inbuilt in mould) 1.5KW/Zone 15. Electric Motor 2.2 KW 16. Total connected load 5.2 KW 17. Hyd. Oil requirement 50 Ltr. 18. App. Weight 1200 Kg. Features of the press:-
- Double hydraulic press mounted on common base with common hydraulic power pack
- Manual De-gassing facility to remove air and gases from the powder/compound.
- Moving Platen guided on 4-tie bars which are heat treated and ground and hard-chrome plated, guided thru DU bushes.
- T-slots provided on both platens for die clamping.
- Insulation on both platens to prevent heat transfer towards press body by imported material.
- All control valves of Bosch Rexroth/Yuken/Polyhydron.
- Electric motor with ISI mark (Crompton/Kirlosker/Bharat Bijlee/Hindustan Engineers/Sabar).
- Low noise level below 75 dB.
- Common Control panel between two presses consists of main switch, MCBs for heaters, and motor.
- Separate hand operated directional control valves for presses for mould closing and opening.
- Separate temperature control for setting individual temperature for two presses with two zones. (Total 4 nos. temperature controllers)
- Parallity between two platens within 0.10 mm. (Excluding sindhania sheet )
- Pilot check valves on DC valves for leak free holding of pressure and hence clamping.
|
